Steps 1 - 3

Dig a hole in the soil deep enough to hold the plastic bucket. Using tin snips or a drill, create a ½-in. notch in the bucket rim. Put the bucket into the hole with its rim at ground level. Set the pump in the bucket.
 

 

2. Using tin snips, cut a square opening (about ½ in. across) in the center of the mesh square.

3. Attach the plastic tube to the pump, then thread it through the center opening in the steel mesh. Position the mesh square atop the bucket. Pull out the free end of the pump's power cord; position so it exits the bucket through the cut notch.

Step 4
Slide the plastic tubing's free end through the drain hole of the large pot.
 

 

Step 5

Center the large pot atop the steel mesh and slide it down the tubing until it sits firmly on the mesh.